Heating, Cooling & Plumbing Services in West Chicago, IL

Performed a furnace tune-up on a 16+ year old unit, including inspection of the burner assembly, heat exchanger compartment, and venting. Burners were found to have rust and corrosion with soot buildup, and the flue vent pipe showed heavy moisture streaking and residue at the seam, indicating possible condensation or corrosion that warrants further evaluation. Recommend follow-up repair or replacement consideration given equipment age and observed deterioration.

Responded to callback for a detached PVC exhaust vent found on the ground outside the structure following the previous day's no-heat repair. Inspected the vent termination and reconnected and secured the PVC exhaust sections and couplings at the sidewall penetration, restoring proper venting and ensuring the termination was properly supported and sloped. Verified the furnace operated safely with correct exhaust flow after repairs.

Evaluated an upright gas furnace with an attached whole-house humidifier in a basement utility space for replacement, following a prior diagnosis of a flawed heat exchanger. Assessed the existing equipment, condensate/PVC piping, ductwork connections, and surrounding clearances to determine the proper replacement equipment and installation requirements for the home's comfort needs.

Performed a furnace tune-up on 12+ year-old equipment, including cleaning the pilot light area and inspecting the unit for proper operation. Used a handheld digital meter to check system readings, and visually inspected the adjacent gas-fired water heater, which showed no signs of rust, frost, or damage.

Performed a routine tune-up on a 3-year-old HVAC system, including furnace and humidifier maintenance and a filter replacement. Verified system operation using a digital thermometer for temperature readings and a true RMS clamp meter for electrical measurements, recording a 7.30 A amp draw on the tested component. System was found to be operating properly with no issues identified.

Responded to a no-heat call on a residential furnace reported as failing to ignite. Inspected the furnace, combustion air and condensate piping, venting, and ductwork in the basement mechanical area, and found no visible damage, corrosion, or ice buildup. Performed diagnostics on the ignition sequence and verified system operation.

Completed a furnace tune-up including inspection and service of the heating system, along with a semi-annual filter replacement. Verified system operation and checked supply air temperature with a digital probe thermometer, and inspected the Aprilaire unit and surrounding equipment area, including the sump pit and discharge piping, to confirm no issues affecting system performance.

Performed a comprehensive BFMA tune-up on a 6-year-old furnace, including inspection and servicing of the unit and replacement of the furnace filter and humidifier filter. Inspected the adjacent gas-fired water heater and noted damp, stained concrete near its base for follow-up. Presented a CO PRO in-duct air purification system as an optional indoor air quality upgrade for the existing furnace.

Performed a seasonal furnace tune-up on a one-year-old unit, including inspection of major components, and replaced the air filter with a new pleated filter to restore proper airflow. System was left clean and operating normally, with no deficiencies noted.

Performed an on-site evaluation for a full HVAC system replacement estimate, inspecting the existing gas furnace installed in a utility closet with galvanized supply plenum, round metal ductwork, flue venting, PVC condensate drain piping, and a Trion Air Bear air cleaner. Reviewed the electrical service panel, confirming dedicated, labeled breakers for the furnace and A/C circuits, and found no visible damage, rust, or frost on the equipment. Assessed the home's layout and existing components to determine proper equipment sizing and compatibility for a recommended replacement system.

Performed an on-site evaluation for a full furnace and combo system replacement following a reported cracked heat exchanger on the existing unit. Inspection of the furnace and mechanical area revealed heavy rust, corrosion, and moisture staining on the top casing around the vent slots, along with water spotting on the supply plenum and ductwork and PVC vent piping serving the unit. Documented existing conditions with photos to support recommended equipment replacement options for the homeowner's comfort and system needs.

Performed a complete tune-up on the 10-year-old furnace and humidifier, including inspection of internal components with a borescope, which revealed frost/ice buildup and cracking with rust staining on an interior surface that warrants further evaluation. Removed and inspected the flame sensor, which showed oxidation and carbon residue affecting reliable flame detection, and serviced it to restore proper operation.

Performed a complete tune-up on a Diamond 80 horizontal gas furnace, inspecting the cabinet, gas supply piping, electrical connections, and supply ductwork, and found the unit elevated on wood blocks over a gravel floor. Inspected the air filter, which was relatively clean with light dust and minor debris, and noted a slightly bent section of the wire mesh grid. The unit's age is unknown, so recommend periodic filter replacement and continued annual maintenance to preserve efficiency and reliability.

Performed an on-site evaluation for replacement of an approximately 32-year-old upright gas furnace that is still operational, inspecting the cabinet, plenum, supply ductwork, condensate/PVC piping, and the mounted whole-house humidifier, with no visible rust, frost, or damage noted. Documented the existing equipment with photos and confirmed the newer AC system can remain in place, then prepared a furnace replacement estimate for installation scheduling in the afternoon window.

Responded to a no-heat call on an Armstrong Air Ultra gas furnace where the blower operated but the unit did not produce heat. Inspected the furnace cabinet and gas valve assembly (White-Rodgers SV9520H), testing gas valve operation and control circuit with a meter to diagnose the ignition and fuel delivery sequence. Documented the equipment condition, noting general dust and age buildup, with the unit and ductwork otherwise intact.

Responded to a water leak complaint at a Trane XV95 condensing furnace. Inspected the cabinet interior and found mineral deposits, water staining, and corrosion on the lower cabinet floor, with damp conditions on the slab beneath the unit, consistent with condensate leakage from the drain or collection system. Documented the findings with photos.

Performed a furnace tune-up and semi-annual filter change, including inspection of the gas valve and control wiring and verification of blower motor amperage with a clamp meter. Inspected the Lennox outdoor unit and noted heavy rust-colored corrosion and buildup on the condenser fan blades and shroud tray, which should be addressed to maintain proper airflow and unit performance.

Performed a complete tune-up on an 11-year-old gas furnace, including inspection of major components, verification of system operation, and temperature measurements with a calibrated true RMS clamp meter and thermocouple. Replaced the air filter with a new 14" x 20" x 1" fiberglass filter to maintain proper airflow, and the system was left operating normally.

Performed a seasonal tune-up on a 7-year-old gas furnace, inspecting the equipment cabinet, supply ductwork connections, and measuring temperature at the plenum with a digital thermometer. Noted rust-colored staining on the concrete floor beneath the unit, indicating possible corrosion or a prior leak, and recommend monitoring this area and checking the condensate and drain components.

Performed a semi-annual furnace tune-up, including filter replacement and a full inspection of the furnace cabinet, wiring, and control board. Conducted electrical testing with a true RMS clamp meter to verify amperage draw on the motor circuit and inspected the hot surface igniter assembly and mounting bracket for proper condition and operation. Confirmed the furnace is operating normally at the end of the visit.