Trusted HVAC, IAQ & Generator Services in Bartlett, IL

Responded to service call for air conditioning system blowing warm air. Performed diagnostic evaluation and tested capacitor with multimeter after homeowner had recently replaced thermostat without resolving the issue. Identified failed capacitor as root cause of cooling failure and documented component condition with electrical connections intact.

Completed comprehensive BFMA tune-up on 12-year-old residential air conditioning system. Inspected outdoor condensing unit and found significant dirt and debris accumulation on condenser coil fins; cleaned and cleared buildup to restore proper airflow and heat transfer efficiency. Inspected indoor air handler and replaced dirty 16x25x1 pleated air filter showing heavy dust accumulation to improve system airflow and indoor air quality. Performed standard preventive maintenance procedures including checking refrigerant levels, testing electrical connections, verifying proper thermostat operation, and ensuring all components functioning within manufacturer specifications. System operating normally upon completion with improved efficiency and airflow.

Completed comprehensive AC tune-up on outdoor condensing unit over 3 years old. Performed electrical diagnostics using clamp meter to verify system amperage and voltage readings, inspected capacitor condition and all electrical connections, and evaluated overall system performance. All components found operating within normal parameters with no immediate repairs required.

Completed comprehensive BFMA air conditioning tune-up on 10-year-old system. Performed full system inspection including electrical disconnect examination, verified all terminal connections secure with clean copper contacts, inspected evaporator coil assembly showing good condition with minimal debris accumulation, checked capacitor and electrical wiring integrity, and assessed copper refrigerant lines for proper insulation and connections. All components operating within normal parameters with routine maintenance completed per manufacturer specifications.

Conducted comprehensive sales estimate for full HVAC system replacement in residential basement mechanical room. Evaluated existing furnace, air handler, ductwork configuration, and auxiliary equipment including humidifier and condensate pump system. Assessed current equipment condition, installation quality, and proper connections of all mechanical components. Documented existing gray furnace unit with metallic ductwork, wall-mounted humidifier with associated copper and PVC piping, and condensate management system. Photographed complete HVAC setup to prepare customized equipment replacement proposal matching home's specific comfort requirements and system specifications.

Completed comprehensive BFMA tune-up service on residential HVAC system with 6-year-old equipment. Performed full inspection and maintenance of outdoor condenser unit, verifying proper operation of compressor, fan motor, and condenser coil condition. Conducted combustion analysis and carbon monoxide safety testing on water heater, recording readings of 11 ppm CO with maximum level of 22 ppm, confirming safe operation within acceptable parameters. All systems tested and operating within manufacturer specifications.

Completed comprehensive BFMA tune-up on 17+ year old Trane outdoor condensing unit. Performed full system inspection, tested electrical connections at disconnect box, verified proper operation of compressor and condenser fan motor, cleaned condenser coils, checked refrigerant levels, and ensured all safety controls were functioning correctly. Unit operating within manufacturer specifications upon completion.

Completed comprehensive AC tune-up on two aging HVAC systems, both over 9 years old. Performed standard maintenance protocol including inspection of all major components, air handler evaluation, and filter assessment. Addressed customer concern regarding Nest thermostat connectivity issue with AC unit, troubleshooting communication between thermostat and air conditioning system. Inspected air filter showing moderate dust accumulation and discoloration, examined air return grille, and verified proper airflow through ventilation system. Evaluated drain pan and condensate line for proper operation. All systems checked for optimal performance and efficiency.

Responded to no hot water complaint at commercial facility. Upon inspection, found Rinnai tankless water heater installed and operational in mechanical room. Verified unit power supply, gas connections, and exhaust venting were properly configured. Tested hot water flow at multiple fixtures throughout building and confirmed adequate hot water delivery to all locations except reported shower head. Traced plumbing distribution system and determined issue was isolated to individual fixture rather than water heater malfunction. Tankless unit displaying normal operating parameters with no error codes present. Recommended client contact plumbing division to inspect shower valve cartridge and fixture-specific supply lines for potential blockage or mechanical failure at point of use.

Completed comprehensive BFMA tune-up service on residential HVAC system consisting of one 16+ year old air conditioning unit and one 5-month old Lennox furnace with AprilAire humidifier integration. Performed standard maintenance procedures including filter inspection, system operation verification, electrical connection checks, condensate drain line assessment, and thermostat calibration on both heating and cooling equipment. All components found operating within manufacturer specifications with no immediate repairs required at time of service.

Completed comprehensive BFMA tune-up service on 4-year-old BDP air conditioning system. Performed thorough cleaning of heavily soiled condenser coil which exhibited significant dust and debris accumulation in fins, replaced air filter as part of semi-annual air cleaner maintenance, and conducted full AC system inspection. Unit was found operational with outdoor condensing unit showing normal weathering for age; all routine maintenance tasks completed per BFMA service protocol.

Completed comprehensive BFMA tune-up service on 6-year-old HVAC system during scheduled morning appointment. Performed AC system maintenance including inspection of outdoor condenser unit, verified proper operation of fan assembly and compressor, and replaced heavily soiled 20x25x1 air filter that showed significant dust and debris accumulation. Dryer vent cleaning service was completed as part of recurring maintenance program to ensure proper airflow and system efficiency.

Installed a new 40-gallon Bradford White tanked water heater in the residential utility room adjacent to the existing Lennox furnace. Connected copper supply and discharge lines to the top of the unit, secured all piping with appropriate hangers and strapping, and positioned the water heater on a code-compliant base platform with proper clearances for ventilation and service access.

Conducted comprehensive water heater evaluation on an 8-year-old Bradford White 40-gallon natural gas unit (Model M140T6FBN) that had been recently flushed by the homeowner. Performed visual inspection of the tank exterior, verified all manufacturer labels and safety warnings were intact, assessed copper supply line connections at the top of the unit, and documented current condition with photographs for estimate purposes.

Completed comprehensive full system HVAC estimate for residential property, evaluating existing outdoor air conditioning condenser unit positioned on concrete pad adjacent to vinyl-sided structure and indoor furnace system located in utility room. Assessed gray condenser unit with cylindrical top fan grille showing typical outdoor weathering, verified unit placement on concrete base with surrounding landscape considerations, and documented electrical connections and manufacturer specifications. Evaluated indoor furnace equipment including ductwork configuration, flexible metallic duct routing, associated piping systems, and electrical connections in confined utility space. Provided equipment replacement recommendations and upgrade options based on current system condition, operational status, and homeowner comfort requirements for properly sized HVAC solution.

Completed comprehensive air conditioning tune-up on 24+ year old outdoor condenser unit. Performed standard maintenance protocol including inspection of electrical connections at contactor assembly, which showed significant oxidation and aging consistent with equipment age, cleaning of accumulated debris and cobwebs from terminal block area, and verification of proper system operation. Unit operational upon completion with customer advised of equipment age and condition.

Responded to service call for water leak in basement originating from HVAC system installed earlier this year. Upon inspection, identified active leak at water supply line connection to furnace-mounted humidifier. Repaired leaking water line connection to humidifier, verified proper seal, and tested system operation to confirm leak resolution. No further issues observed at time of service completion.

Responded to bathroom plumbing issue and successfully replaced corroded shower valve stem that was causing operational problems. The old valve stem showed significant oxidation and green patina buildup, which was replaced with a new brass component to restore proper water control functionality in the shower system.

Provided comprehensive estimate for complete air conditioning system replacement including new outdoor condensing unit and indoor evaporator coil. Assessment included evaluation of existing equipment placement and feasibility of relocating outdoor condenser unit to more optimal position on exterior of residence. Documented current HVAC configuration in basement mechanical room with furnace, ductwork connections, and existing refrigerant lines, as well as current condenser location adjacent to building exterior wall to determine scope of work required for system upgrade and equipment relocation.

Responded to service call for failed sump pump with active water leakage in basement utility area. Upon inspection, found existing pump inoperable with evidence of chronic water seepage indicated by extensive rust staining and mineral deposits radiating across concrete floor from basin location. Removed and disposed of failed unit. Installed new 3/4 horsepower sump pump to provide increased pumping capacity and improved reliability. Verified proper operation of discharge line through existing white PVC piping system. Tested pump activation and cycling to ensure proper float switch function and adequate water removal. Applied military discount as requested. System operational upon completion with enhanced pumping performance.